This is super fast but also vulnerable: If one SSD fails, all data is gone. This means that the data is distributed between both drives. If you want to get the most out of your old MacBook, you can connect a SSD on both interfaces and configure it to a RAID 0.
A very good solution for price-sensitive users. For average use actually faster than purely mechanical plates. This combination of mechanical hard disk and approximately 8 GB SSD combines the best of two worlds. If you are not so keen on speed but still want to have a lot of capacity without living in the past, you can use a SSHD. Make sure to transfer the four small screws on the hard disk to the new SSD. The mechanical hard disk is defective, a new SSD is coming in. (tested with 2012 MacBook Pro > problems and with 2011 > stable despite SATA 6 and SSD)īut which combinations make sense? Here are a few words about the configurations: So if you have a Macbook Pro that supports SATA 6 on the second port, ironically a mechanical disk belongs here, otherwise you run into problems with the stability. For 2011 models, check the System Profiler to see if the second connection is the newer version or not – both standards have been used.
There are examples where this works, but in most cases MacBook will cause trouble if it is from 2012 or 2011 and both internal SATA ports support the newer variant.Įverything is fine until 2010, you can install the SSD where you want. What sounds nice at first brings a huge disadvantage: SATA 6 SSDs do not run stable at this connection for some reason. When upgrading, please note the following: In 2011 Apple started to switch the second SATA port (which connects to the DVD drive) from SATA 3 to SATA 6. So with larger models there are still a few more seconds in it. And this with one (or two) relatively small 64 GB SSDs, which we used for testing.
The previously usual start time of 45 to 60 seconds is now just over 20 seconds. The 2011 MacBook Pro also benefits greatly from an SSD. It just takes a few years off the device. In everyday use, however, the difference between mechanical disk and SSD is easily felt. Here, the age becomes noticeable after all. To sum up: An SSD is always worthwhile, no matter in which combination.Īs you can see in the table, the 2008 MacBook always boots stoically in 40 seconds. You can find the boot times in the table, the felt experiences and further tips follow below. We wanted to know what effect the corresponding combinations have on boot time and general usability. We used a 13″ MacBook made in 2008 with 2 GHz and a 2011 model with 2.3 GHz for testing.
Power and performance in a good value package Huge capacity for small money, also in 2 TB Huge capacity in a reliable package, also as 2 TB and 4 TB variantĮxcellent speed and durability, also in 2 TB and 4 TB Very cost effective and fast enough for older MacBooksįor normal use very sufficient reliability and very fastĭesigned for very many writing operations, extremely durableįor older MacBooks or office machines sufficient, very good value In heavy duty use even more durable than Evoįast even when almost full, a bit higher capacity than others | MacBook Pro Retina | MacBook Air | Upkeep overview | We don’t list 128 GB models any more as prices are so cheap that a 256 GB SSD should be the smallest choice. These are good value, fast and give your MacBook a new lease on life. SSDs for MacBook Pro Late 2008 to Mid 2012 without Retina Display Suitable SSDs for Model Nummer A1286, A1297 and A1278 and Model Identifier: